Furman M-8S 15A Power Conditioner w/ Sequencer
• Protect your valuable equipment with surge protection and noise filtration.
• Enjoy the convenience of power sequencing, preventing excessive inrush currents.
• With 9 total outlets, including 6 sequenced rear panel outlets and 2 unswitched rear panel outlets, plus 1 front panel convenience outlet, it's perfect for any rack mount system.
Install the M-8S in your rack, and the outlets will power up in sequence, safeguarding all your gear up to a 15-amp load. It's the ideal low-cost AC power solution for those seeking power sequencing in their rack mount setups.
Includes 3 delayed outlet banks - each with 2 outlets - plus 2 unswitched outlets.
- Power Sequencing
- Prevents excessive inrush currents.
- Six sequenced rear panel outlets (in three groups), two unswitched rear panel outlets, and one front panel unswitched outlet.
- Momentary and maintained sequencing via rear panel terminal block or front panel switch (momentary only).
- Noise Filtration
- Noise filtering to reduce radio frequency and electromagnetic interference.
- Surge Protection
- Ensures equipment stays safe.
- 9 Total Outlets
- Eight rear panel outlets and one front panel convenience panel outlet.
- 15 Amp Rating
- 15 amp rating, with circuit breaker.
- 'Protection OK' Indicator
- Front panel indicator LEDs for Outlet Banks, Protection OK and Power Status.
- Wall Wart Spacing
- Rear outlets have been spaced to accommodate even the bulkiest of wall warts and adapters.
- All settings and configurations available on rear panel.
Specifications:
General
- Family: Merit Series
- Line Voltage: 120 (Volts)
- BlueBolt Enabled: No
AC Protection
- Automatic Voltage Shutoff: No
Shipping Info
- Length: 21.9 (Inches)
- Width: 9.4 (Inches)
- Height: 3.4 (Inches)
- Weight: 7.65 (Lbs)
- Unit of Measure: Each
- UPC: 654061041078
- Master Pack Qty: 6
Other Specifications
- Maximum AC Current Rating: 15 Amps, 120 VAC (Thermal breaker)
- AC Cord: 14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug
- Convenience Outlet (Front Panel): 1 Un-switched NEMA 15-5R
- Rear Panel Outlets:
- 2 Un-switched NEMA 5-15R (1 duplex)
- 6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)
- AC Surge Protection: Merit Class (sacrificial)
- Spike Protection Mode: Line to neutral, zero ground leakage
- Max Continuous Operating Voltage: 130V RMS
- Max Clamp Voltage: 500 Volts Peak
- Peak Impulse Current: 12,000 Amps
- Energy Rating (2 X 820μS): 225 Joules
- AC Filtering
- Pi LCR Filter
- Noise Attenuation
- >26dB, 100 Khz to 1 MHz
- Operating Temperature Range: 5C (40F) to 40C (105F) degrees
- Humidity Range: <90% rH (Relative Humidity)
- Rocker Switch: Front panel, Sequence (On/Off)
- Thermal Circuit Breaker: Front panel, push to reset
- Front panel indicators: Delay 1, Delay 2, Delay 3, Power, Protection Ok
- Control/Status/Triggering (Rear Panel): Rear Panel DIP Switches: 12V Mode On/Off, GND Mode On, Momentary/Maintained
- Potentiometer: Rear panel, time calibration fine tune delay adjust
- Remote Terminal: +5-30VDC In, 12VDC (12mA) Out
- Remote Terminal: Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring)
- Size: 1.75' X 19.00' X 6.5' (HWD) – ANSI 1RU
- Mass: 5.3 lbs.
- Power Consumption (No Load): 5 Watts
- Safety Agency: C/CSA/US

The Furman M-8S 15A Power Conditioner with Sequencer is a must-have for anyone with a rack mount system. Ideal for protecting valuable equipment like audio systems, computers, and more. Its 9 outlets, including 6 sequenced rear panel outlets and 2 unswitched rear panel outlets plus 1 front panel convenience outlet, can handle a 15-amp load. It offers power sequencing to prevent inrush currents, noise filtration to reduce interference, and surge protection to keep your gear safe. Measuring 21.9 inches in length, 9.4 inches in width, and 3.4 inches in height, weighing 7.65 lbs, it's easy to install and use. Keep your equipment protected and running smoothly with the Furman M-8S 15A Power Conditioner with Sequencer.